多功能攪拌車底盤進行正確的潤滑可以減少汽車零件的磨損，增加攪拌車零件的使用壽命，但是在實施潤滑時應注意一下幾點：
Proper lubrication of the chassis of the multi-function mixer can reduce the wear of vehicle parts and increase the service life of the mixer parts. However, the following points should be noted when implementing lubrication:
1、正常使用情況下，按攪拌車廠家的保養周期進行潤滑，環境惡劣情況下要適當縮短保養周期。
1. Under normal use, lubrication shall be carried out according to the maintenance cycle of the mixer manufacturer, and the maintenance cycle shall be appropriately shortened under harsh conditions.
2、更換發動機機油時，要在熱狀態時進行，以保證油能放盡。放油時應注意檢查機油顏色是否正常、機油有無異物，以便發現故障隱患。待油放盡后，放油螺栓上的異物，然后擰緊。
2. When changing the engine oil, it should be carried out in the hot state to ensure that the oil can be drained. When draining oil, pay attention to check whether the oil color is normal and whether there are foreign matters in the oil, so as to find hidden trouble. After the oil is drained, tighten the foreign matters on the oil drain bolt.

3、要選用規定的潤滑油。代用油料須性能接近，主要技術指標須保證，并且用代用油應時常檢查，且縮短使用周期。
3. The specified lubricating oil shall be selected. The performance of the substitute oil must be close, the main technical indicators must be guaranteed, and the substitute oil should be checked frequently, and the service cycle should be shortened.
4、換機油濾芯：更換機油時，機油濾清器要同時更換，在密封墊上涂上一層薄薄的油，并且緊固濾清器。
4. Change engine oil filter element: when changing engine oil, the engine oil filter shall be replaced at the same time, a thin layer of oil shall be coated on the sealing gasket, and the filter shall be fastened.
以上就是為大家介紹的有自上料混凝土攪拌罐車廠家的詳細的介紹,希望對您有所幫助.如果您有什么疑問的話,歡迎聯系我們.我們將以的態度,為您提供服務http://www.kunapops.com/
The above is a detailed introduction of the manufacturer of self feeding concrete mixing tank truck. I hope it will be helpful to you. If you have any questions, please contact us. We will provide you with professional services http://www.kunapops.com/